per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
1
13
article
Design and Implementation of Hardware in the Loop Tester for a Tactical Missile Flight Computer with Hybrid Guidance
amir yaghoobi
yaghoobicontrol@gmail.com
1
Mohammadreza Arvan
arvan@mut.ac.ir
2
Abbas Taghipoor
ataghipoor2006@yahoo.com
3
Ali Nassrollahi
alinasrollahi544@gmail.com
4
Malek Ashtar University of Technology
Malek Ashtar University of Technology
Malek Ashtar University of Technology
Emam Khomeyni ghazvin
One of the most common methods in development and evaluation of aerospace systems is the hardware in the loop (HWIL) test which the part of the system that must has been developed or evaluated its performance, are in hardware and other parts of the system are in software mode put in the flight simulation loop. This test is a closed-loop and real-time simulations that for its implementation, a platform named hardware in the loop test are used. In this paper the design and implementation of HWIL tester of a tactical missile flight computer system with hybrid guidance is presented. Flight computer is an essential subsystem of missile that calculations of guidance and control are done in it. This subsystem for guidance and control algorithms Implementation, collect data from seeker and other missile sensors including free gyroscopes that measure rolling angle, potentiometer of control fins and sending the appropriate commands to actuators for correcting the path of missile. For verifying the performance of this flight computer can use open loop and close loop tests. In this paper for close loop verifying of flight computer, a HWIL tester, is designed and implemented. This tester consists of two parts: hardware and software that aims to create conditions close to reality for evaluating the performance of flight computer hardware. After design of this tester, its results are compared with results of six degree of freedom missile simulation in various scenarios that the appropriate consistency of results shows the accuracy of planning.
http://joc.kntu.ac.ir/article-1-124-en.html
Flight computer
HWIL tester
6DOF Simulation
DSP processor.
per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
15
30
article
Distributed Optimal Control of Nonlinear Differential Graphical Games based on Reinforcement Learning
Farzaneh Tatari
fa_tatari@yahoo.com
1
Mohammad-B Naghibi-S
mb-naghibi@um.ac.ir
2
Ferdowsi university of Mashhad
Ferdowsi university of Mashhad
This paper introduces continuous time nonlinear differential graphical games and proposes an online distributed optimal control algorithm to solve them. In differential graphical games, each agent error dynamics and performance index depend on its neighborsâ€™ information. The proposed online distributed policy iteration algorithm solves the cooperative coupled Hamilton-Jacobi equations. In this algorithm which is based on reinforcement learning, each agent uses an actor-critic neural network structure where the weights of these neural networks are tuned synchronously. While all actor-critic networks are learning, closed loop stability and convergence to optimal control laws are guaranteed. Finally simulation results demonstrate the validity and performance of the proposed algorithm.
http://joc.kntu.ac.ir/article-1-176-en.html
Artificial neural networks
Nonlinear differential graphical games
Optimal control
Reinforcement learning.
per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
31
41
article
Optimal Glucose-Insulin Regulatory System in Type1 Diabetic Patients Based on the Nonlinear Time Delay Models
Mohamad Sadegh Akhyani
sadegh_akhyani@ee.kntu.ac.ir
1
Hamid Khaloozadeh
h_khaloozadeh@kntu.ac.ir
2
In recent decades, control systems theory is used in many industrial and medical issues. Various control strategies are applied to this medical issues such as diabetes which is used to maintain normal glycemia in the patients suffering from diabetes. Obtain the appropriate insulin infusion rate in order to keep the patientâ€™s glucose levels within predefined limits is always an interesting subject for physicians. Nonlinear time delay differential equations are well known to have arisen the diabetic patient modeling. Nonlinear time delay modeling leads to a small number of equations, but the control method will be far more complex. In this paper a new technique is introduced to solve optimal control in nonlinear time delay systems, called ESDRE. A nonlinear state feedback is designed to track the desired glycemia for a diabetic patients based on pseudo linearization method. This method gives suboptimal solution for the problem. The stability of the closed-loop systems based on the ESDRE technique is also studied. Using this method, the optimal insulin infusion rate as the control signal is obtained and glycemia in type1 diabetic patients converges to the desired normal range. The results of the proposed method are compared with the Palumbo's nonlinear controller which is based on feedback linearization. The results of the simulations, represents the efficiency of the proposed method.
http://joc.kntu.ac.ir/article-1-180-en.html
Optimal control of diabetic patient
Nonlinear time delay systems
Pseudo linearization
DDE models
ESDRE method
per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
43
53
article
Control Of Wind Turbine With Double Fed Induction Generator To Track For Maximum Wind Power
Mahmood Abolhasani zarjoo
mahmood.pe@gmail.com
1
Seyed Babak Mozafari
mozafari_babak@yahoo.com
2
Turaj Amraee
amraee@kntu.ac.ir
3
islamic azad university, science and research branch, tehran
islamic azad university, science and research branch, tehran
Among renewable energies, wind energy has attracted more attention since 1991. The main objective for utilization of the wind plant is to reduce cost and environment pollution. It is well known that the power delivered by wind turbines which are directly coupled with grid is not constant as a result of wind variability. Thus in spite of sudden wind speed variations, farm generators should always be capable of extracting maximum possible mechanical power from the wind and converting it in to electrical power. Variable speed wind turbines are commonly equipped with doubly fed induction generators (DFIG). In fact, doubly fed induction generators are wound rotor induction generators that their stators are connected to grid directly and their rotors are connected to grid through two PWM back to back power electronic converters.
This thesis focuses on control of a grid-connected doubly fed induction generator (DFIG) based wind turbine system in order to track maximum absorbable power in different wind speeds.
First, the dynamic model of wind turbine, gear box and DFIG is developed. Then, a generalized regression neural network (GRNN) is used to estimate wind speed and the maximum absorbable power is determined through a look up table for per wind speed.
Finally vector control employs PI controller to calculate the required rotor control voltage for control of active and reactive power and obtaining maximum power from wind turbine. Simulation results on 1-MW wind turbine are provided and show the effectiveness of the new technique, for tracking maximum power. Also, this scheme has acceptable harmonic spectra of stator current from the perspective power quality. MATLAB/Simulink(R2012b) software has been used for simulating.
http://joc.kntu.ac.ir/article-1-191-en.html
Wind Turbine
Doubly Fed Induction Generator
Vector Control
Neural Network.
per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
55
64
article
Robust Stabilization of Switched Linear Systems, Based on State Feedback Observer and Dwell Time Switching Signal
Mohamad Ali Bagherzadeh
ma.bagherzadeh@ec.iut.ac.ir
1
Jafar Ghaisari
ghaisari@cc.iut.ac.ir
2
Javad Askari
j-askari@cc.iut.ac.ir
3
Mohsen Mojiri
mohsen.mojiri@cc.iut.ac.ir
4
Stabilization of switched linear systems is one of the most important problems in the area of switched systems. In this paper, a design method for robust stabilization of parametric uncertain switched linear systems is proposed in terms of linear matrix inequalities. First, a method is proposed assuming that all states are available. This method designs the state feedback gains, such that the closed-loop system to be robustly asymptotically stable under switching signals with the known minimum dwell time. Since the states are unmeasurable in some practical systems, the method is then extended to the practical cases, in which the outputs are just available. The observer-based stabilizing state feedback gains are designed to stabilize such systems robustly for dwell time switching signals. The asymptotic stability of the proposed methods is proved under the assumption that all the nominal subsystems are controllable and observable. Then, the method is also generalized for robust stabilization of uncertain switched linear systems under any arbitrary switching signal. The correctness and effectiveness of the results are illustrated by some numerical examples.
http://joc.kntu.ac.ir/article-1-186-en.html
Switched linear system
parametric uncertainty
robust stabilization
observer-based state feedback
dwell time switching signals
per
Iranian Society of Instrumentation and Control Engineers
Journal of Control
2008-8345
2538-3752
2015-03
8
4
65
76
article
Performance Improvement of Uncertain TCP-Networked Control Systems Using Robust AQM
Masoumeh Azadegan
azadegan64@gmail.com
1
Mohammad Taghi Hamidi Beheshti
mbehesht@modares.ac.ir
2
Babak Tavassoli
tavassoli@eetd.kntu.ac.ir
3
Abstract: This paper presents AQM design to improve the performance of networked control systems. An analytical model of the transmission control protocol (TCP) network is considered and a PID-type state feedback controller is developed to regulate the queue length. This leads to keeping network induced delay and its variation to be small enough to improve the overall performance of the NCSs. The model is assumed to possess structured uncertainties due to the stochastic nature of the network. By augmenting the TCP model with the plant equations, the closed loop system is transformed to a state-dependent delay differential equation (SDDDE). Applying the Lyapunov-Krasovskii method, a sufficient condition for the stability of this class of systems is obtained in terms of linear matrix inequality (LMI). PID controller parameters will be determined by solving these LMIs. Simulation results are presented and it has been shown that maximum allowable bound of time delay will increase in the proposed method.
http://joc.kntu.ac.ir/article-1-205-en.html
Uncertain Networked control systems
Active queue management
Linear matrix inequality
Lyapunov-Krasovskii